Preparing for Paint Front End VW Beetle

I spent the day today applying bondo to smooth out the remaining wrinkles. I still have a long way to go to get everything tidy and ready to paint, but the dimples and pin holes are disappearing between the welding and putty application.

I  finished welding the bolt retainer inserts for the front left quarter panel. The hood seal channel was completely rusted so I welded a new one in place. The old one came off easily as it was tack welded and flimsy. The new weld went on easy. I welded it on, ground the rough edges and primered it. I'm not a good welder and you can see where the channel melted a bit. It will hold though.

Also sanded off the remaining glue and tar paper from the interior. Should be finished with this part soon.

Where does all the
rust come from. This is the interior
where the headline fits down the door post

Scrubbing off the old glue and rust from the roof.

Just cleaning up the dash for paint later.

I can't wait to get this bug painted. I'll miss the work though.


I'm going down to metal on my project, but here's a great place to get a new padded dash.

Remove and Replace VW Beetle Headliner

 I removed the headliner and saved the bows. I'll use them again, but since the seals, windows and all hardware has been removed, I can get a good coat of paint applied and have a new headliner installed with professional results. I do plan on installing a folding, slide back roof. How fun. 

Currently, my efforts will involve sanding down the old adhesive so that only bare metal is exposed. Then I'll primer it and prep for painting.

New Interior Color for 1969 VW Beetle

I am sanding and repainting some interior parts to make them off white. This will look great with the green exterior and give it a more retro feel. My father is skilled at painting small components and did a great job with the stick shift and parking brake knobs.

Welding fender bolt inserts onto the wheel wells

New front apron after weld

Welding is something that I haven't mastered. It's hard to find training and while it looks easy on Youtube, welding is fundamentally hard for me. But, it is something that I'm glad to have partial grasp of.

New front apron clip before weld

I tried to tackle welding 

in the new front apron. I successfully sliced off the old piece, but had no idea how to weld in the new piece. My lack of knowledge of geometry, welding and body work became overwhelmingly evident. That's why I'm glad to have had a referral to a skilled and affordable welder.

Since then I have aggressively tackled welding in bolt receiver inserts into the 

New bolt inserts

fender wells. The prior owners used various bolt, washer and nut combinations to secure fenders where the old bolt receivers have rusted or otherwise popped out. Now I have barbarically welded them in. My challenge is the smaller holes left as the new inserts were not as large as the vacant holes. I may fill these in with putty or attempt to weld in small pieces of sheet metal or spot weld with a copper spoon. Either way I am closer to being finished.

I've sanded down the trunk are and just need to smooth out dents, dings and wrinkles that the apron replacement did not cover. My plan is to do a coat of black primer followed by grey. After sanding, the entire area should be black. Any grey areas will indicate low areas that need to be brought out.